THE PEAVEY T-40 BASS ENTHUSIASTS FORUM
Would you like to react to this message? Create an account in a few clicks or log in to continue.

THE PEAVEY T-40 BASS ENTHUSIASTS FORUM

A FORUM FOR PEAVEY T-40 BASS ENTHUSIASTS
 
HomeLatest imagesRegisterLog in

 

 Question about string height and neck tilt

Go down 
2 posters
AuthorMessage
bloody hammer




Posts : 2
Join date : 2010-12-30

Question about string height and neck tilt Empty
PostSubject: Question about string height and neck tilt   Question about string height and neck tilt I_icon_minitimeTue Jan 04, 2011 6:36 pm


Does anyone have any advice or experience with the following? I was reading in the user manual how the neck tilt feature should be the primary source for adjusting string height and the saddles more for fine tuning. My question is... on this T40 that I just got, the saddles are varying heights and I wondering if I need to set them back to default before I start messing with the neck tilt. Does anyone know what the factory height would've been for the saddles?
Back to top Go down
NGPeavey




Posts : 14
Join date : 2010-04-24
Location : NW Georgia

Question about string height and neck tilt Empty
PostSubject: Re: Question about string height and neck tilt   Question about string height and neck tilt I_icon_minitimeThu Jan 06, 2011 5:14 pm

Your best bet is to go to the peavey t40 mafia forum to get an answer from people who know. This site is too full of spammers anymore. I hope this helps.
Back to top Go down
 
Question about string height and neck tilt
Back to top 
Page 1 of 1
 Similar topics
-
» T-40 neck tilt
» Neck plate question..
» Bridge and string spacing
» How do I set the PU height?
» putting a 5 string set on a t-40

Permissions in this forum:You cannot reply to topics in this forum
THE PEAVEY T-40 BASS ENTHUSIASTS FORUM :: T-40 DISCUSSION :: PEAVEY T-40 DISCUSSION-
Jump to: